Payment & Shipping Terms:
Geogrid Reinforcing Fabric Plastic Uniaxial Geogrid made by HDPE and PP Material
Plastic Uniaxial Geogrid was made by high density polyethylene as its raw material, produced through plate-extruding, punching, heating, stretching. After stretching, the messy chain constructurt will be orioutated again to get a linear state, so that the plastic uniaxial geogrid enhances its tensile strength & rigidity. By laying it into the foun- dation soil, the stress transmission organ will the constructed through the meshing and lock between the mesh hole and soil, to spread the partial to wide soil base, rapidly & efficiently. Then the partial destroy stress will be lowed down, the lifespan will be elongated.
Geogrid Reinforcing Fabric Plastic Uniaxial Geogrid Feature:
(1)High unidirectional tension resistance, good creep resistance and stable chemical nature.
(2)It has large friction factor with sandy stone.
Plastic Uniaxial Geogrid made by HDPE and PP Material Specification:
|Plastic Uniaxial Geogrid made by HDPE and PP Material|
|Raw material||HDPE and PP||HDPE and PP||HDPE and PP||HDPE and PP||HDPE and PP||HDPE and PP||HDPE and PP|
Tensile Yield Strength
|Yield Strength at 2% elongation (KN/m)||14||18||23||29||35||39||47|
|Yield Strength at 5% elongation (KN/M)||27||35||44||55||65||74||85|
|Yield elongation ratio (%) ≤||12||12||12||12||12||12||12|
Maximum creep Strength
Contact Person: service-7